-
- Newly Registered
- Posts: 2
- Joined: Wed May 23, 2018 1:05 pm
Help with drip system
Hello everyone! I’m new to hydroponics growing and have set p a system that is not going very well. I have attached an image of the system. More or less using clay pebbles as a growing medium and have transplanted plants that I started from seeds and took out of the dirt pods when they were ready. I rinsed the clay people’s for 24 hours prior to using them. I have the system setup in sunroom and the drip system is set to a consistent drip. I have put hydroponics food in the reservoir. Please help, what am I doing wrong? Thank you in advance!
The seedlings are not getting enough light. We started seedlings in plugs and grew them out for a couple of weeks in plug trays using oasis plugs. You don't need to take the media off and the sponge helps to hold water and the roots together. Your tubing is just tubing,it does not water evenly. This is a trickle down system. I am used to aeroponic towers where an emitter goes to every cup or there is a spray at the top that trickles down the sides and wets the roots in the cups. The center of the tower is hollow. Hydroton is used more for grow beds. I am used to oasis foam as growing media for rails and towers.
https://www.youtube.com/watch?v=4B-QAT2RuCw
https://www.youtube.com/watch?v=4B-QAT2RuCw
-
- Newly Registered
- Posts: 2
- Joined: Wed May 23, 2018 1:05 pm
I take it you used jiffy pellets. You should not have to remove the nets, the roots will grow through that. I have used peat plugs we used sunshine #4 mix for the media in 1 inch plugs in grow beds, only oasis foam in hydro systems mainly because the water would wash away the soil and clog the system. I think washing the soil was not the problem, mostly not enough light and uneven distribution of the water.