Growing a vertical Garden
Posted: Tue Feb 05, 2008 5:43 pm
I've been doing some research on growing my own vertical garden [url]https://www.pingmag.jp/2006/12/08/vertical-garden-the-art-of-organic-architecture/[/url]
And I was hoping I could get some opinions about the materials I'm using and proper care etc.
My plan (based on the wikihow [url]https://www.wikihow.com/Make-a-Living-Wall[/url]) is thus:
I purchased a freestanding fireplace spark guard (made of copper) at thrift store to use as the frame for my growing substrate. I also purchased a roll of synthetic winter blanket material for plants. I have an old aquarium pump and a lot of tubing to circulate the hydroponic solution.
I plan to stitch several layers of this material together (about 5cm thick once complete) and suspend inside the spark guard frame. I will then cut small holes in the material about halfway through to insert the young plants/seeds.
A catchbasin will be set up underneath the length of the substrate to catch all leftover water and the aquarium pump will recirculate it, sending it to distribution tubes which I will insert through holes drilled into the top of the spark guard.
My plan is to have the water slowly dripping over the length of the top of the whole system, permeating the substrate and supplying my plants with all necessary nutrients; my hope is that this constant water movement will also help prevent mold and mildew growth.
What do you guys think?
And I was hoping I could get some opinions about the materials I'm using and proper care etc.
My plan (based on the wikihow [url]https://www.wikihow.com/Make-a-Living-Wall[/url]) is thus:
I purchased a freestanding fireplace spark guard (made of copper) at thrift store to use as the frame for my growing substrate. I also purchased a roll of synthetic winter blanket material for plants. I have an old aquarium pump and a lot of tubing to circulate the hydroponic solution.
I plan to stitch several layers of this material together (about 5cm thick once complete) and suspend inside the spark guard frame. I will then cut small holes in the material about halfway through to insert the young plants/seeds.
A catchbasin will be set up underneath the length of the substrate to catch all leftover water and the aquarium pump will recirculate it, sending it to distribution tubes which I will insert through holes drilled into the top of the spark guard.
My plan is to have the water slowly dripping over the length of the top of the whole system, permeating the substrate and supplying my plants with all necessary nutrients; my hope is that this constant water movement will also help prevent mold and mildew growth.
What do you guys think?